One northern and industrial potential tools source of serious injury in grinding comes from an oversight that 5in is easy to make: operating the wheel in an over-speed high condition. While a wheel that is run speed far enough in excess of its rated maximum sander speed model and 15892 and northern may shatter industrial within tools and 5in minutes of operation, danger high and speed may also result from a wheel sander and model and 15892 run northern just slightly faster than its rated speed. This less severe over-speed industrial condition can cause the wheel tools to be damaged, and the damage may result in breakage after further 5in and high use. For example, operating a reinforced, 9-inch diameter, Type 27 wheel rated for a maximum speed of 6,600 rpm speed on sander a 7-inch angle grinder model with a speed of 7,700 rpm can cause the wheel to 15892 crack. This cracking can northern and industrial and tools and 5in and high lead to speed breakage sander later. Any model of these 15892 actions northern and industrial and tools and 5in sets up a disastrous scenario high that could lead to an speed accident sander and model involving serious 15892 injury or death.

In northern short, never over-speed a grinding wheel. The speed of the grinder industrial must be compared to the speed marked tools on the wheel or package to make sure 5in and high and speed the machine''s speed is at or below the maximum operating speed of the wheel. Surpassing this rating risks not just wheel breakage but also the safety of shop personnel. sander and model and 15892 and northern About the author: Roger Cloutier is industrial a senior product safety tools engineer 5in for the high Norton Abrasives brand speed of Saint-Gobain sander and model Abrasives in Worcester, 15892 Massachusetts.

©2003 www.airsanders.com. All rights reserved.