One potential ingersoll source rand of serious vertical injury in grinding comes from an oversight that air is easy to make: sander operating the wheel in an over-speed condition. model and ir319 and ingersoll While a wheel that is run far enough in excess of its rated maximum speed rand and vertical and air and sander may shatter model within minutes of operation, danger may also result from a wheel run just slightly faster than its rated speed. This less severe over-speed condition can cause ir319 the ingersoll wheel to be damaged, and the damage rand may result in breakage after further use. For example, operating a reinforced, vertical and air 9-inch diameter, sander Type 27 wheel rated for a maximum speed of 6,600 rpm on a 7-inch model angle ir319 grinder with a speed of 7,700 rpm can ingersoll cause the wheel to crack. This cracking can lead to breakage later. Any of these actions sets up a disastrous scenario that could lead to an accident involving rand serious injury or death.

The hazard of running man vertical over-speed air and sander condition comes model from centrifugal force. ir319 and ingersoll and rand A result of rotary motion, centrifugal force vertical is what causes a weight air on the end of a string to pull the string taught when the weight is swung in a circle. This same sander force causes the mass of the grinding wheel to be model pulled outward from the center of rotation ir319 as the wheel is spinning.

©2003 www.airsanders.com. All rights reserved.